I put a 3/4 hp Consew BLDC motor on my vertical mill.
I also put one on my Bandsaw.
I have another eventtually for my lathe.
These are from Ebay at $99.00 I might buy some more just to have at hand.
I did the mill and bandsaw two years ago and they both work great, I have run the mill and bandsaw at 500 rpm and less on the motor and still got good torque.
On Sun, Mar 25, 2018 at 8:16 AM, old_toolmaker@yahoo.com [7x12minilathe] <7x12minilathe@yahoogroups.com> wrote:
OK, I think I understand most of what has been said so far. It must then be possible to use a hall effect sensor with to BLDC. Is that correct and can that be used on the mini lathe? Can that be done in a nice tidy fashion?
__._,_.___
Posted by: Ralph Hulslander <rhulslander@gmail.com>
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (55) |
Have you tried the highest rated email app?
With 4.5 stars in iTunes, the Yahoo Mail app is the highest rated email app on the market. What are you waiting for? Now you can access all your inboxes (Gmail, Outlook, AOL and more) in one place. Never delete an email again with 1000GB of free cloud storage.
.
__,_._,___
No comments:
Post a Comment