I agree with Ian, I have never encountered a precision rod from a shock absorber or printer that is any better than common drill rod - whether in concentricity, straightness, or consistency over a certain length.
The best thing to do for a test rod, is to make one. Just chuck up some stock in whatever method you have, center drill each end. Then set it up between centers and take light cuts, making adjustments to the tailstock until you get a nice round diameter over its length.
On Sunday, August 14, 2016 5:03 PM, "Ian Newman ian_new@yahoo.com [7x12minilathe]" <7x12minilathe@yahoogroups.com> wrote:
Hi Michael,
It is a myth that the bars from the inside of printers are made to extreme levels of accuracy - they are no better than normal ground stock, but usually have the advantage of being free if you can be bothered to strip down machines being thrown out.
Whether the bar will make a useful "test bar" depends on what you are trying to test....
All the best,
Ian
On 15 Aug 2016, at 00:38, 'Michael Jablonski' michaeljab@cox.net [7x12minilathe] <7x12minilathe@yahoogroups.com> wrote:
Well yesterday I disassembled my old inkjet printer (Epson 740). This was done to remove the printer's print head carriage rod which several people here have said would make a good test bar.First let me say that this particular printer does not come apart very easily. I don't know how many tiny Philips head screw needed to be removed, but it was a lot! After thinking several times that this was not worth all the time and effort, I was finally able to remove the print head carriage rod.The rod is about 14.5 inches long but is only 9 mm (0.354") in diameter. Each end is turned down to 0.120" about 0.250" long. I was hoping that the rod would have been center drilled on each end, but no such luck.I haven't done anything with it yet, but was concerned that the 9mm diameter was a little on the thin side, and that either sag or flex of the rod would render the measurement readings inaccurate.Opinions?
Michael - California, USA
Micro-Mark MicroLux 7x16
LMS 3990 Hi-Torque Mill with power feed
__._,_.___
Posted by: Carlos Akin <carlosakin@yahoo.com>
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (3) |
Have you tried the highest rated email app?
With 4.5 stars in iTunes, the Yahoo Mail app is the highest rated email app on the market. What are you waiting for? Now you can access all your inboxes (Gmail, Outlook, AOL and more) in one place. Never delete an email again with 1000GB of free cloud storage.
.
__,_._,___
No comments:
Post a Comment