That's too bad, so connect your voltmeter set on ACV to the terminals
of the coil and switch the washer on.
You will see what voltage is applied to the terminals and can buy a
contactor accordingly.
Don't worry too much about the contact ratings, this is a small
contactor and they likely took what was available rather than
designing to any particular requirement. Most likely any contactor you
can find will do just fine as long as the coil voltage is right.
ST
On Wed, Jul 18, 2012 at 7:23 PM, jimybud <jimybud@casscomm.com> wrote:
>
> Of course, the location you mention is burned, please see photograph below.
>
> I may try and scrape it and determine if i can uncover the voltage.
>
> http://groups.yahoo.com/group/Electronics_101/photos/album/710205676/pic/513228158/view?picmode=large&mode=tn&order=ordinal&start=1&dir=asc
>
>
>
> ------------------------------------
>
> Please trim excess when replyingYahoo! Groups Links
>
>
>
No comments:
Post a Comment