that thing is ugly replace it and yes you should be able to check the
incoming wires to the n/o switch to determine what the voltage is
On Wed, Jul 18, 2012 at 11:00 AM, jimybud <jimybud@casscomm.com> wrote:
> **
>
>
> How would I test the coil within this contact?
>
> Also, with a multimeter should I also be able to tell what voltage the
> coil is?
>
> Also, I am assuming that when power flows thru the coil that creates the
> mechanical energy to cause the contacts to touch.
>
> I know am no longer able to get any part of the pressure washer to work.
> Previously the water pump would work but not the heating unit. Know I can
> not get any functionality via the swith.
>
> When I manually push down on the contactor switch the water pump does
> work, but not the heating unit.
>
> Below is a photograph
>
>
> http://groups.yahoo.com/group/Electronics_101/photos/album/710205676/pic/593771835/view?picmode=large&mode=tn&order=ordinal&start=1&dir=asc
>
>
>
--
jeremy youngs
[Non-text portions of this message have been removed]
------------------------------------
Please trim excess when replyingYahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Electronics_101/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/Electronics_101/join
(Yahoo! ID required)
<*> To change settings via email:
Electronics_101-digest@yahoogroups.com
Electronics_101-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
Electronics_101-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
No comments:
Post a Comment