The easiest way to do that is to replace the motor pulley with a smaller one. IIRC, there was some recent discussion, complete with SDP part numbers on the 7x12 group.
http://www.sdp-si.com/
Roy
--- In 7x10minilathe@yahoogroups.com, "tom_rittenhouse" <tom@...> wrote:
>
> Thanks, that is an idea I will look into. I am also thinking about adding reduction to the drive.
>
>
> --- In 7x10minilathe@yahoogroups.com, "Roy" <roylowenthal@> wrote:
> >
> > You may be able to adjust the pots on the speed control board to improve low end torque. There's a generic procedure here:
>
> > Still, for really controllable high torque low speed work, a hand crank can't be beat!
> >
> > Roy
>
__._,_.___
MARKETPLACE
.
__,_._,___
No comments:
Post a Comment