I'm very careful with it and have only used it on the lathe. It is a parallel model and the tip moves in the same plane as the dial face.
I noticed last night I went to use and the tip was not vertical. I dont' think I bumped it or snagged it on anything. Is there an adjustment that allows the tip to be repositioned at some other angle than vertical?
Thanks,
Jody
_._,_._,_
Groups.io Links:
You receive all messages sent to this group.
View/Reply Online (#102225) | Reply To Group | Reply To Sender | Mute This Topic | New Topic
Your Subscription | Contact Group Owner | Unsubscribe [jhjoshan@gmail.com]
_._,_._,_
No comments:
Post a Comment