Bill, I'll admit to not knowing the answer in numbers, but I had to do one and this is what I did....
I cleaned off the shaft and put a working MT2 in the tailstock so it seated (I think it was one of my drill chucks) and shot it with a little Dychem. I popped that out and measured it. Mess was all cleaned up with Dychem solvent and I had the answer.
Warren L
On 12/23/2015 1:10 PM, Bill Vance mlt@xpresso.seaslug.org [7x12minilathe] wrote:
I've seen it often enough, but now can't seem to find it.
Assuming I start with an MT2 test bar, how much would I
need to saw off the taper to make it compatable with a
7x* minilathe?
Bill
__._,_.___
Posted by: Warren LeMay <notebook@squarework.com>
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (2) |
.
__,_._,___
No comments:
Post a Comment