Album;
"Beyond Basics"
Photo shows my set up to test the Power Feed using a 4" Diameter
carbide tipped Slotting Saw.
Jerry G (Glickstein)
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (1) |
Album;
"Beyond Basics "
Photo shows the Test Piece bottom being counter bored to
accommodate the protrusion of the Sherline T-Nut above the Mill table.
Jerry G (Glickstein)
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (1) |
Album;
"Beyond Basics "
Photos show the preparation for a test piece to try out the Power Feed.
6061 Aluminum 3/4" by 1 1/2" by about 6 1/4"
It has been aligned to the X axis , ends milled.
Next step is to center drill, drill and counter bore mounting holes.
# 10's, of course.
Jerry G (Glickstein)
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (1) |
